Nortec Industries MES ElectrodeSteam Humidifiers Instrukcja Użytkownika

MES ElectrodeSteam HumidifiersInstallation, Operation,Maintenance, Spare Parts, andExploded Views GuideIMPORTANT: Read and save this guide for future

Software requirements for Modbus RTUModbus addresses:4XXXX – R/W3XXXX - RCommand Description MODBUSaddressDetailsOutput ControlOFFDisables thehumidifi

-9-Set MODBUSparity *Change the humidifier controller’sMODBUS parity.Range is None, Even, OddThis setting shall be non-volatile with adefault setting

-10-MaximumproductionThe rated maximum steam productionfor the humidifier30802ValuewrittenintoUnittype(40600) is also stored hereAlarms The humidifier

-11-MES-U/MES-P HUMIDIFIERPHYSICAL DATAMESU DIM 10/19/98WEIGHTS (DRY)DIMENSIONSNOTES:1. FOR HEIGHT OF 5 LB PVC USE HEIGHT OF 10 LB MODEL.2. PVC = PRIM

-12-MES-U INTERNAL AND FIELD WIRINGWIRING DIAGRAM number 150-6240 REV. B(For PVC or LVC unit with remote or attached electrical)STEAM CYLINDERNOTE: SO

- 13-

- -14-POS.DESCRIPTIONCommentsNORTEC208/380/208/380/208/380/208/380/NOPA RT230/460/230V460/230V460/230V460/NUMBER277V575V575V575V575V1Cylinder - To ord

- 15-

LIMITED WARRANTYWalter Meier Inc. and/or Walter Meier Ltd. (hereinafter collectively referred to asTHE COMPANY), warrant for a period of two years fro

Table of ContentsINSTALLATION 1RECEIVING EQUIPMENT ...1PRINCIPAL OF OPERATION ...

Walter Meier (Climate USA) Inc.826 Proctor Avenue, Ogdensburg, New York 13669Walter Meier (Climate Canada) Ltd.2740 Fenton Road, Ottawa, Ontario K1T3T

INSTALLATIONRECEIVING EQUIPMENT1. Check packing slip to ensure ALL material hasbeen received.2. Inspect box for damage and note on shippingwaybill acc

WATER SUPPLY AND PLUMBING1. The fill valve is sized for an extended waterpressure range of 30 to 80 psi.2. For cases below 15 psi add a pressure boost

The red light simply acts as a safety to shut off thefill valve and prevent over-filling. With the red light on,the water in the cylinder will continu

dependent on water supply conditions and humidifierusage. Failure to replace the cylinder at the end ofcylinder life may result in unit damage. NORTEC

FOAMING: The phenomenon which can occur inwater when the impurities, already in the water reachan excess concentration as a result of boiling awaypure

Water remains at high level and won’t concentrate:This is normal on cold start-up and can beaccelerated by adding maximum 1/2 tsp. of dissolvedsalt to

DIAGNOSTIC PROCEDURES - TROUBLESHOOTING GUIDEUnit Status LampSymptom Corrective actionsYellow GreenOn On Maximum water levelinside cylinder.This usual